Data on laser machine size and ecc..

Demand to factory

floor-gas-ecc is below

FIBER LASER VS CO2 is below

Software below

 CUTTING LASER POWER TO SPEED AND PERFORMENS

image002

image001

image003

 

MACHINE SIZE NEDED IN WORKSHOP

size 2530

sice L3030-1

sice L4030-1

sice L6030-1

 

 

 DEMAND TO INSTALLATION in factory

NOTE we recommend a trumpf engineer to install the laser machine this is to make sure your machine work properly after installation

TO lift the machine from truck you need special separator to avoid damage to the machine.. CRANE capacity min 12 ton or more

Floor must be min 200 mm thick with arming no creaks or connections in arrear where main machine must stand. this is to make sure machine not move and change setting

temperature in factory must NOT drop below +5 deg due to cooling water

the recommended temperature is + 15 to +30 deg

but best operating temp is +20 to +25 deg

the GAS needed to the laser is

HE 4.6  –   CO2 4.5   –  N2 5.0  at 5 bar in to laser

cutting gas

O2 3.5  min 10-15 bar

N2 2.8 min 25-30 bar at hi flow 60m3/min

COMPRESSED AIR   MIN 7 bar clean air, no olie or water in air

machine coming from europe need 380/400 volt at 50 hz tolerance +-5%

apr fuse needed according to laser power

laser 1,5 kw 80 amp

laser 2,2 kw 100 amp

laser 3,2 kw 125 amp

laser 4,0 kw 160 amp

LASER TO BE USED AT 60 HZ MUST BE UPDATED TO OTHER POWER

FIBER LASER VS CO2 laser.

There is no doubt that the fiber laser is the future,,,, BUT ONLY IF YOU BAY NEW MACHINE.

today the co2 laser is still the best laser type for sheet cutting wen you think as supplier and 2 hand machine

Fiber laser only work wen you bay NEW machine 2 hand machine DON’T work.

2 hand befor 2015 simply don’t work then co2 laser is better.

the fact is that used fiber laser hartley don’t work or perform because is the first serie of fiber laser

use strong lamp to generate the laser beam and the cost to operate is higher then a used co2 laser

on many new fiber laser is the laser beam generated by diodes that is mutts stronger and got longer lifetime this type use also less energy and perform better but are usually designed for ether thin or thick material. this men that you can not cut like the co2 laser all the way.

but note on almost all fiber you can not do any work yourself you need engineers for almost all work you can not even change the cutting linz ..!!!!!!.

also many fiber laser got cutting problem even new machines as they can only cut thin material and not all material like co2 laser can do

 

SOFTWARE

 we recommend TRU TOPS from TRUMPF

this software offer the best result and the best performing postprocessor

we also offer small training in use wen you bay the software together with our used machines

NOTE we do not sell the software seperate if you need only the software you must contact TRUMPF

At the moment we do not support  other software then TRU TOPS

if you bay a used machine from us and you those other software we do not have any responsibility for that the machine NOT perform because of the software

 

Comments and questions are welcome.

Contact Form
* indicates required field